Where is the rear view camera located?
Your back-up camera is located in the rear of your car. It is connected to a display screen that shows you what is happening in the area behind the vehicle.
Where does the power cable go for a rear view camera?
Pull the splitting end of your camera’s video and power cable through the drilled hole into the trunk of your car. Make sure you pull it tight so the rubber grommet lodges into the drilled hole. Your camera cable should run from the outside of the car to the inside of the car.
What’s the best way to install a rear view camera?
Attach 1 of your bare wire cables to the camera cord’s power connector. Then, poke your bare wires through the center of the exposed reverse light wires and twist them together. For safety, make sure you wrap the combined wires in electrical tape.
How does a rear view camera attach to a license plate?
If the camera attaches to the back of your license plate, line the device up with the plate’s fastener holes and thread screws through them. In most cases, you can attach a rear-view camera to the back of your license plate using the screws you removed from the car earlier.
What kind of Monitor do I need for rear view camera?
An external backup monitor is a small video screen that mounts onto your windshield similarly to a GPS. Though they take up more space than internal monitors, external monitors are far easier to see and can be easily replaced if necessary. If you’d like, you can use a standard video monitor instead.
Attach 1 of your bare wire cables to the camera cord’s power connector. Then, poke your bare wires through the center of the exposed reverse light wires and twist them together. For safety, make sure you wrap the combined wires in electrical tape.
Pull the splitting end of your camera’s video and power cable through the drilled hole into the trunk of your car. Make sure you pull it tight so the rubber grommet lodges into the drilled hole. Your camera cable should run from the outside of the car to the inside of the car.
How do you connect a reverse camera to a backup light?
1. Connect the positive and negative power supply wire of reverse camera with the positive and negative leads of Backup Light (Reverse Light). When the backup light turns on, the reverse camera turns on as well. NOTE: DO NOT connect the power supply wire of reverse camera with Brake Light or Tail Light.
If the camera attaches to the back of your license plate, line the device up with the plate’s fastener holes and thread screws through them. In most cases, you can attach a rear-view camera to the back of your license plate using the screws you removed from the car earlier.
