Where is the coolant reservoir on a Ford?
Open the hood and locate the engine coolant reservoir. It is often a translucent white color, and has hose (s) connecting it to the radiator. The reservoir has a fill range marked on the side. If your engine is cold, the coolant level should be up to the cold fill line.
What kind of coolant does a Motorcraft engine use?
G = Green-colored engine coolant approved to Ford specification ESE-M97B44-A (Motorcraft® Premium Antifreeze/Coolant) O = Orange-colored engine coolant approved to Ford specification WSS-M97B44-D or WSS-M97B44-D2 (Motorcraft® Orange Antifreeze/Coolant)
What kind of coolant do you use on a Ford?
You can use diluted coolant by itself, or a 50/50 mixture of concentrated coolant and distilled water. When the coolant rises to the cold fill line, replace the cap and tighten it until you feel it click. Close the hood. Ford Motor Company has used four different types of coolant since 2002. Here are the colors as well as the relevant models:
How to flush a Ford V10 motorhome radiator?
Close the system and start the engine. Allow it to run for two or three minutes and then shut it off. Top off the system with a 50/50 mixture of coolant and distilled water. Recheck the coolant level and add as needed after approximately 20 miles of driving. Never work on a hot cooling system.
G = Green-colored engine coolant approved to Ford specification ESE-M97B44-A (Motorcraft® Premium Antifreeze/Coolant) O = Orange-colored engine coolant approved to Ford specification WSS-M97B44-D or WSS-M97B44-D2 (Motorcraft® Orange Antifreeze/Coolant)
What kind of coolant should I use on my Ford F-150?
The gold is good for 150,000 miles according to Zerex. While some other members stressed to the OP to not use General Motors’ Dex-Cool coolant, mistaking it with Ford’s orange or gold coolant. Note that Dexcool is also gold/orange, and you should NEVER use it in a Ford.
When to change the coolant on a Ford V-10?
The Ford maintenance schedule says to change the Premium Gold coolant after 5 years. The service instructions I found on the Ford web site say to just drain the radiator and refill. Does anyone know what percentage of the coolant gets drained this way? Does the V-10 have drain plugs to allow the block to be drained?
How much coolant does a Ford 4.2L have?
My 4.2L has 1.75g in the radiator and 2.45g in the block. DW’s 3.6L has 0.75g in the radiator and 1.65g in the block. Our 460 in the RV has 3g in the radiator and 3g in the block.
