What kind of cable do you use to lift a camper?
This is done using a lifting system composed of winches, cables, springs, and pulleys. However, there are different types of camper lifting systems depending on the brand and model, even though the earlier versions are basically lifted using a simple system composed of a cable and a winch.
Where does the cable for the pop up camper come from?
In the Goshen lift system, the cable originates from the winch and connects to a system of pulleys, which are centrally located underneath the pop-up camper. There is also a tube running from a distribution case to each of the four corners of the RV.
Where are the lifter cables on a Jayco camper?
Replace any lifter cable that shows signs of fraying, breakage, rust or other damage. The Jayco’s four lifter cables attach to the harness block with eye bolts and are routed to the drive slugs via pulleys. When the winch reels in the main cable, the lifter cables pull the drive slugs along a track bolted to the floorboard.
How do you change the cable on a lifter?
Detach the cable from the drive slug, and remove the other end from the eye bolt at the harness square. Loosen the eye bolt nut and lock nut to allow for adjustment later. Measure the cable and replace it with a new length of the same diameter. Most lifter cables are 3/32 inch.
This is done using a lifting system composed of winches, cables, springs, and pulleys. However, there are different types of camper lifting systems depending on the brand and model, even though the earlier versions are basically lifted using a simple system composed of a cable and a winch.
In the Goshen lift system, the cable originates from the winch and connects to a system of pulleys, which are centrally located underneath the pop-up camper. There is also a tube running from a distribution case to each of the four corners of the RV.
How to replace lift cables in a Jayco camper?
Replacing the lift cables in a Jayco camper is simple but labor intensive. Replacement requires new materials and access to the pulleys and winch system. Replacing the lift cables in a Jayco camper is simple but labor intensive. Replacement requires new materials and access to the pulleys and winch system. Check this website resource.
Detach the cable from the drive slug, and remove the other end from the eye bolt at the harness square. Loosen the eye bolt nut and lock nut to allow for adjustment later. Measure the cable and replace it with a new length of the same diameter. Most lifter cables are 3/32 inch.
