What does DSi stand for in a furnace?
Combustion Chamber – The metal box where propane and air are burned. DSI – is an acronym for Direct Spark Ignition. It refers to the use of an electronic Igniter to fire the propane instead of a pilot light. Ducts – round or rectangular tubes that carry heated air from the furnace to the RV interior.
Why does my Atwood flame furnace not light?
Needless to say, no gas would reach the burner if the valve fails to open. Take a look at the valve and assess its quality. In most of the case, you should be able to replace the gas valve at moment notice without much difficulty. 4. Flawed Igniter After you activate the furnace, the igniter would generate sparks and ignite the propane gas.
What does it mean when your furnace wont ignite?
A bad wiring between the igniter and the circuit board can also mean the furnace wont ignite. Another reason could be a dirty spark ignitor. It will not allow the spark to reach the burner and the fuel. Another common problem where in the fan runs but there is no heat or very less heat in the furnace.
Why does my Atwood hot water heater not ignite?
The atwood hot water heater burner will ignite when you flip the switch to on position and water gets hot. After that the burner will not ignite any more on its own until you flip the switch again. RV Make: Keystone Sprinter, RV Model: KBS300, RV Year: 2010, Brand: Keystone Sprinter, Model Number: KBS300
Why is my Atwood 8531 furnace not igniting?
It turned out to be in the gas valve not getting the proper pressure to the heater. Lifted the little cap off the gas valve and inside turned the inserted screw very gently till it stopped. Do not tighten. The furnace has worked perfectly ever since. I found that my atwood 8531 furnace would not ignite unless I pounded on the side of the furnace.
What is the DSi FAULT light on Atwood RV water heater?
I spoke with my contact at Dometic (who took on the Atwood water heaters) and they said that the DSI fault light on the switch for your Atwood RV Water Heater # AT94022 (GC10A-4E) will only come on for two reasons.
Where is the sail switch on an Atwood furnace?
The furnace is rated to be safe and not ignite if the blower doesn’t produce enough air flow (70%). The sail switch is located on the underside of the blower motor (squirrel cage) housing. The switch is held in by two screws.
Combustion Chamber – The metal box where propane and air are burned. DSI – is an acronym for Direct Spark Ignition. It refers to the use of an electronic Igniter to fire the propane instead of a pilot light. Ducts – round or rectangular tubes that carry heated air from the furnace to the RV interior.
