What causes an RV slide out to malfunction?
Typical slideouts are either hydraulic (a larger slide) or electric (a smaller slide): 1 Hydraulic systems Hydraulic systems use the principle of hydraulic pressure and it is more common on larger-sized slides. 2 Electrical systems A variety of electrical issues could cause RV’s slideout to malfunction. 3 Motor issues
Why is my slide out motor not working?
RV Slide Motor not Working. The bad news is that one of your slide out motors may have died. The good news is that the failure is due to a faulty wire or connection which caused a short and tripped a breaker. The latter may not be the case if you have 2 motors on your slide out and one is still working.
How to troubleshoot a Lippert slide out in an RV?
To help you figure out next steps after you determine the problem lies in the hydraulic system, RV expert Dave Solberg walks you through a quick inspection of the underside of the slide room.
What kind of motor does an RV slide out use?
RV’s slideout system is operated by a 12 volt DC electric motor and you need to make sure that you supply it with enough power through a converter or a fully charged 12-volt battery. Your vehicle is leveled. You need to level your vehicle before operating the slideout. Your transit bars are removed.
Are there any problems with the slide out on an RV?
Troubleshooting RV Slide Out Problems: One main problem with slide outs is that they may get out of alignment. The good news here is that each slide can be adjusted separately. All you have to do to fix it is take your RV to a dealer and let them make an adjustment.
Why does my slide not retract after new motor?
After the new motor was installed, the slide still would not retract. The “square rods” connected to the motor were detached to assure the new motor was functioning. We found that power to the motor existed only when the “out” part of the slide’s in/out button was pushed. There was no power to the motor when the “in” side of the button was pushed.
Where is the slide out controller on a motorhome?
For my motorhome, there are two slide out controllers attached to the “roof” of the middle basement compartment between the two main beams of the frame. One controller for the passenger side slide-out and one for the drive side slide-out. RV Masters charged $130 for the new controller and $140 for an hour of labor to install the controller.
Where are the rods that drive the slide out?
The opening is just to the left and below the yellow wire screw caps (first photo with old motor) Square rods that drive the slide bars are attached on both sides of the motor gear box (second photo with new motor). The slide-out that was stuck open is also shown below.
