How do you adjust a Kelsey brake controller?
“Depress the brake pedal just far enough to illuminate the tow vehicle brake lights. Use a finger to pull the pendulum leveling arm (a small lever on the left side of the unit) toward the front of the Kelsey trailer brake controller and confirm that this makes the control module indicator light glow brightly.
How does a Hayes trailer brake controller work?
Hayes controllers have an exclusive four-wire connector that when used with a vehicle-specific wiring harness enables the brake controller to essentially be plugged in and ready to go. Other Hayes-specific features include how the controllers activate the trailer stop lights when the brake control is manually activated.
What are the settings on the brake controller?
This means that with the trailer attached and the engine running, the operator pulls the manual override lever on the controller all the way to the left—maximum brake. While holding the lever, you then adjust the power control knob until the digital setting shows a 6 on the display.
How to troubleshoot your trailer brake controller system?
Here are a few tips. First, connect the trailer to the tow vehicle in order to engage the brake controller. While inside of the vehicle make sure it is visible and easily accessible. Keep the manual close. Second, examine the trailer brake controller.
What should the gain be on a trailer brake controller?
For larger trailers, use a higher gain setting. For smaller trailers, a lower gain setting should be used to avoid brake lockup. To set trailer brake gain, start with the values specified by the manufacturer. Test your trailer brakes at 25mph.
Which is trailer brake controller does Hayes towing use?
Designed and developed by Hayes Towing Electronics/Syncro Corporation engineering with assistance from Auburn University and outside automotive car and truck vehicle stability control engineers, the SwayMaster® is designed to provide simultaneous braking when sway is detected to all trailer brakes on 1 to 4 axle trailers.
How to adjust trailer brakes for RV travel?
Just go slow at first, 5mph, apply vehicle brakes to see if trailer is braking at all, adjust until you feel the trailer braking some but not skidding. Go a little faster, 20mph, apply brakes to see if you feel trailer braking, adjust just a little more if necessary. By this time I am at the stop sign before pulling out on the hiway.
For larger trailers, use a higher gain setting. For smaller trailers, a lower gain setting should be used to avoid brake lockup. To set trailer brake gain, start with the values specified by the manufacturer. Test your trailer brakes at 25mph.
How do you set sensitivity on Trailer Brake Controller?
Sensitivity is how aggressively your brake controller will apply the brakes. You can set sensitivity by testing the trailer brakes again. Drive forward at about 25 mph and press the brake pedal. If the vehicle stops too slowly, increase the sensitivity setting. If it stops too abruptly, lower the sensitivity.
