How do I do a gathering stitch?

To run the gathering threads, set your sewing machine to a long straight stitch (3.5mm at least), and stitch a first line 3/8” from the edge, without backstitching. Leave at least a couple inches of thread hanging loose at each end of the seam. Stitch a second parallel line, 7/8” from the edge.

What Stitch do you use to gather fabric?

The traditional method of gathering uses a double row of long basting stitches sewn ⅛” apart within the seam allowance. NOTE: In our example below, we’re using a plain fabric with brightly colored thread so you can see the technique.

Where is the stitch selector on a sewing machine?

A spindle on top of your sewing machine that holds a spool of thread. Stitch Length Selector (or Stitch Length Regulator). Allows you to choose how long your stitches will be.

Why do you sew 2 rows of stitching when gathering?

Remember to pull from the bobbin thread which is less likely to break. When there are more rows, the gathers have a chance to be more even and controlled. With the three rows of basting the stitching line went between the second and third stitches.

What is the difference between gathering and easing?

Easing and gathering are ways of controlling extra fabric to join two cut edges that are not the same length. Easing controls a little extra length, while gathering controls a large amount. The purpose of easing is to give a small amount of shaping.

How do you calculate shirring?

Measurement A: For the length of the bodice, measure from your armpit to where you want the shirring to end. Add 3.25 inches to this measurement. Measurement B: For the width of the bodice: measure across the fullest part of your bust. Add 10.5/12.5/14.5 (for small/med/large) inches to this measurement.

How do you find the stitch setting on a Kenmore sewing machine?

Select a stitch setting by turning the knob or dial or pressing the buttons. Depending on your model, you may have a chart on the machine or in the manual that shows what each setting will look like. Lower the presser foot and sew 5 or 6 inches to get a sense of the look of the stitch setting.

How do you make a gathering stitch without a sewing machine?

Draw up the threads from one end to gather the fabric about halfway across, then turn it and gather the remainder from the other end. Use a single strand of thread and 1/2-inch long stitches to prepare the stitching lines to gather fabric without a sewing machine.

What do you need for a Kenmore sewing machine?

When you need parts and accessories for your Kenmore sewing machine, trust Sears PartsDirect to have the Sears sewing machine parts you need. Bobbin. The bobbin is a small thread reel that holds the bottom thread in the bobbin case.

How to thread a Kenmore sewing machine spool?

Pull the thread through the hole of the bobbin. 1 Make sure that the bobbin spool is flipped so that the hole appears on the top, rather than the bottom. 2 The bobbin winder shaft usually lies to the right of your spool pin. 3 As you place the bobbin on its shaft, make sure that the thread wraps around it a bit from the bottom of the bobbin.

When was the last Kenmore sewing machine made?

Kenmore Model 158 Sewing Machine Instructions | eHow.com. Manufactured by Singer, the Kenmore 158 was sold in the late 1970s and is one of the last mechanical sewing machines offered by Sears.

What’s the best stitch setting for a sewing machine?

Pick the setting you prefer to use for your sewing project. In general, decorative stitch settings are used for top stitching and on pockets, collars and quilts; they are not practical for sewing seams. Zigzag stitches are ideal for sewing knit fabrics or appliqué, while straight stitches are best with woven cloth.